Using Pmod of PS-Side of Zedboard

[mosambers]

Hello,

I am trying to generate a Digital Output by using the Zynq Processing System. I tought using the Pmod would be easy to handle but I am already failing to design the hardware to activate the Pmod MIO.

Do you know a (or similar) tutorial for that? Can you give some advises how to realize it?

 

Thank You!

 

Best regards

[jpeyron]

Hi @mosambers,

I believe the mio pins are part of the FIX I/O. I was able to generate a bit stream using the block design I have attached below along with the xdc I have not used the mio Pmod port. Here is a forum thread where we blinked the MIO_LED on the zybo that might help with the sdk portion of your project.

cheers,

Jon 

mio.xdc