I am using a pmod GPS with a zybo z7-10 board. However, even after running the sample code for the GPS, nothing is being printed on the serial monitor. I'm not entirely sure whether I have connected the pmod right, since there are 6 pins on the GPS but 12 pins on the pmod port. Nowhere has anyone mentioned whether one should connect the pmod GPS on the top six pins or the bottom six pins. Am I doing something wrong here or is there some other problem? I have also attached a picture of my block diagram for reference.
Question
Abhinav Airan
I am using a pmod GPS with a zybo z7-10 board. However, even after running the sample code for the GPS, nothing is being printed on the serial monitor. I'm not entirely sure whether I have connected the pmod right, since there are 6 pins on the GPS but 12 pins on the pmod port. Nowhere has anyone mentioned whether one should connect the pmod GPS on the top six pins or the bottom six pins. Am I doing something wrong here or is there some other problem? I have also attached a picture of my block diagram for reference.
Link to comment
Share on other sites
9 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.