How can I enable Jtag to debug software on Arty A7 board

[Zack]

Hello,

I bought Arty-A7 development board and I will use it for Risc5.
How can I connect a host pc to this board for using openocd?
This board has 'FT2232HQ' and does it mean that I can use USB port for JTAG and UART at the same time?
(Or should I buy any other cables for using openocd?)

Thanks,

[jpeyron]

Hi @Zack,

Welcome to the forums. Unfortunately I have not used openocd. I would suggest to reach out to their support here. Here is a forum thread discussing openocd using the JTAG-HS2.

cheers,

Jon