Not sure where the appropriate place to post this is, but it seems like there's an error in the Using the Network Analyzer manual page. It looks like Ch2+ is connected to the input of the RC filter and Ch1+ to the output, so the two have been swapped. This seems to be confirmed by the plot shown further down in "Run the Network Analyzer", in which C2 is showing the flat input while C1 is showing a response curve, even though the small diagram on the top right of the image shows C1+ at the input and C2+ at the output.
Question
fizzbang
Not sure where the appropriate place to post this is, but it seems like there's an error in the Using the Network Analyzer manual page. It looks like Ch2+ is connected to the input of the RC filter and Ch1+ to the output, so the two have been swapped. This seems to be confirmed by the plot shown further down in "Run the Network Analyzer", in which C2 is showing the flat input while C1 is showing a response curve, even though the small diagram on the top right of the image shows C1+ at the input and C2+ at the output.
Or am I misinterpreting something there?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now