PMOD devices with ZCU102

[itsnathan]

I have some PMOD devices to test out on a ZCU102. Are there any resources for doing this? I tried to test out the PIR module but Vivado says this IP has board specific outputs.

[JColvin]

Hi @itsnathan,

Most of Digilent's IPs are made with Digilent's board files in mind. That being said, you can manually constrain the pins of the IP to whatever pins you need on your board in order to achieve connectivity.

The PIR IP for instance uses AXI GPIO to read in the single output. Alternatively rather than setting up AXI you can make a simple HDL module and then access the data in the Zynq's PS by using EMIO like is done this demo: https://forum.digilent.com/topic/22512-manipulate-pl-logic-using-ps-registers/.

Thanks,
JColvin