I have been following the instruction on https://github.com/Digilent/Petalinux-Arty-Z7-20. These are well done and I got a running image on a SD card from the cloned git repo. Then I switched to the Digilent Apps description, changed some config and recreated the image. This one stopped after the message "Starting kernel..."
After some tries, it turned out that just rebuilding the image even without any change leads to that behaviour. However, cleaning the build will again give a correct image. But I believe thats not the intention to clean for each build... What do I miss?
Question
juergenR
Hi,
I have been following the instruction on https://github.com/Digilent/Petalinux-Arty-Z7-20. These are well done and I got a running image on a SD card from the cloned git repo. Then I switched to the Digilent Apps description, changed some config and recreated the image. This one stopped after the message "Starting kernel..."
After some tries, it turned out that just rebuilding the image even without any change leads to that behaviour. However, cleaning the build will again give a correct image. But I believe thats not the intention to clean for each build... What do I miss?
Thanks for your help, Juergen
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.