I have an example design where I am writing values into a BRAM.
I have confirmed through simulation that the values are stored correctly. However, what I want to do is to confirm that the values are saved running on hardware as well?
I have been trying to debug using the TCF debugger and trying to check the Memory window on the uB but I am not getting anything sufficient or understandable.
What should I do if I want to, for example, test my memory through the MicroBlaze, shall the D-cache and I-cache be enabled?
Could you give me any suggestions or examples on how to confirm the content without using simulation?
My initial goal is to start with a BRAM and then go on with an SDRAM as well.
Question
Azurath
Hello!
I have an example design where I am writing values into a BRAM.
I have confirmed through simulation that the values are stored correctly. However, what I want to do is to confirm that the values are saved running on hardware as well?
I have been trying to debug using the TCF debugger and trying to check the Memory window on the uB but I am not getting anything sufficient or understandable.
What should I do if I want to, for example, test my memory through the MicroBlaze, shall the D-cache and I-cache be enabled?
Could you give me any suggestions or examples on how to confirm the content without using simulation?
My initial goal is to start with a BRAM and then go on with an SDRAM as well.
regards
John
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.