I am trying to program spartan-3e(NEXYS2) using boundary scan based on Digilent Adept JTAG Interface
(DJTG) Programmer’s Reference Manual. And i find a demo(xilinx_jtag_prigramming_linux.c)[1] about how to program
spartan-2 in JTAG mode through a parallel port. I have rewritten a procedure refer to the demo[1] basing on Digilent Adept
JTAG Interface (DJTG) Programmer’s Reference Manual and Spartan-3 Generation Configuration User Guide. But it dose't work.
My question is whether there are some differences between spartan-3e and spartan-2 in JTAG programming? i can not
find the document about configuration and readback of Spartan-3 and Spartan-3e in xilinx website. And how Adept programs
Question
humuji
Hi
I am trying to program spartan-3e(NEXYS2) using boundary scan based on Digilent Adept JTAG Interface
(DJTG) Programmer’s Reference Manual. And i find a demo(xilinx_jtag_prigramming_linux.c)[1] about how to program
spartan-2 in JTAG mode through a parallel port. I have rewritten a procedure refer to the demo[1] basing on Digilent Adept
JTAG Interface (DJTG) Programmer’s Reference Manual and Spartan-3 Generation Configuration User Guide. But it dose't work.
My question is whether there are some differences between spartan-3e and spartan-2 in JTAG programming? i can not
find the document about configuration and readback of Spartan-3 and Spartan-3e in xilinx website. And how Adept programs
spartan-3e in JTAG mode through USB cable?
Any help will be appreciated, thank you!
Link to comment
Share on other sites
12 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.