I'm new to the AD2 and I have a question about the wavegen generator
Can I generate a single pulse output with the AD2 with a variable pulse width? I'm trying to use the square wave out and set it for 1 cycle so I can use the Symmetry slider to be able to select the time (width) for the positive portion of the pulse. I then set the offset to cancel so I'm left with only a positive voltage pulse. The problem is that it appears inverted on an actual scope versus what the Waveforms SW shows graphically for the signal I'm trying to generate.
I would like 0 volts out, until I manually trigger a positive pulse (variable width) and then return to 0 volts again. Is this possible?
Question
catfish
I'm new to the AD2 and I have a question about the wavegen generator
Can I generate a single pulse output with the AD2 with a variable pulse width? I'm trying to use the square wave out and set it for 1 cycle so I can use the Symmetry slider to be able to select the time (width) for the positive portion of the pulse. I then set the offset to cancel so I'm left with only a positive voltage pulse. The problem is that it appears inverted on an actual scope versus what the Waveforms SW shows graphically for the signal I'm trying to generate.
I would like 0 volts out, until I manually trigger a positive pulse (variable width) and then return to 0 volts again. Is this possible?
Thanks in advance
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.