Hi, I want to run simple DMA transfer (not using scatter gather) application program on the attached design.
But the program is always hung when running XAxiDma_CfgInitialize(&AxiDma, Config) function. The JP4 jumper is set on QSPI mode and the running configuration mode is like the figure I attached.
The same program is run and not hung on XAxiDma_CfgInitialize(&AxiDma, Config) if ran on ZYBO. But, with differences in run configuration mode. On ZYBO run configuration mode, I'm not using the initialization file and so not run the ps7_init. On Arty Z7 I need to use it, because if I'm not using it the internal error (No target with ID 64 in the system) will be occured.
Question
anzunden
Hi, I want to run simple DMA transfer (not using scatter gather) application program on the attached design.
But the program is always hung when running XAxiDma_CfgInitialize(&AxiDma, Config) function. The JP4 jumper is set on QSPI mode and the running configuration mode is like the figure I attached.
The same program is run and not hung on XAxiDma_CfgInitialize(&AxiDma, Config) if ran on ZYBO. But, with differences in run configuration mode. On ZYBO run configuration mode, I'm not using the initialization file and so not run the ps7_init. On Arty Z7 I need to use it, because if I'm not using it the internal error (No target with ID 64 in the system) will be occured.
What should I do?
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.