Hi, I am looking to purchase the Genesys 2 Kintex-7 FPGA Development Board for my project design because I noticed that the FMC connector on the FPGA board is at size of 400 pin HPC. And some datasheets said it contains 160 user-defined pins on the FMC connector. I am not sure if these 160 user-defined pins are all needed to be configured on 80 differential pairs. or I can configure them as 160 single-ended pins? Since it is not obviously mentioned in the document, I am quite looking forward to it behaving like 160 single-ended pins. Could you please look that up for me?
Question
tshen46
Hi, I am looking to purchase the Genesys 2 Kintex-7 FPGA Development Board for my project design because I noticed that the FMC connector on the FPGA board is at size of 400 pin HPC. And some datasheets said it contains 160 user-defined pins on the FMC connector. I am not sure if these 160 user-defined pins are all needed to be configured on 80 differential pairs. or I can configure them as 160 single-ended pins? Since it is not obviously mentioned in the document, I am quite looking forward to it behaving like 160 single-ended pins. Could you please look that up for me?
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now