Feedback control loop with MCC E-1608

[Dongyun]

I am trying to set up a feedback control loop that the flow control valve can self-adjust based on the reading from the flowmeter once the desired flowrate is defined. I don't see that DAQami software can do this function since it is not programmable. So I am trying to use LabView to program this. I was wondering if MCC E-1608 can be used with LabView software. Would this be the same as using one of the USB modules from NI? Or are there any limitations to using LabView with MCC E-1608?

[Fausto]

Hello @Dongyun.

MCC's DAQami software application does not support a feedback control loop.  Use your MCC E-1608 with MCC's Universal Library for NI LabVIEW™ in LabVIEW.  (Note:  MCC devices do not use NI-MAX for device configuration.)  Below are a few forum posts regarding MCC's Universal Library for NI LabVIEW™.

 

Regards,

Fausto