Measurement is successful in Tracer-NoAdater mode. I'm looking for a solution by handling the initial value settings.

[Denspa]

I also have a Tracer function adapter, but I made my own to measure large currents.
The measurements are successful using NoAdater mode.
However, I have a slightly complicated problem and would like to ask you a question.
The screen shown is an example of measuring Ic/Vbe characteristics. Vrc=5V fixed state.
For example, let's say you measured with Single.
The initial value of Vrb when measuring for the first time is = 0 (diable).
When the measurement is finished, Vrb is the initial value of 500mV.
Is there a way to automatically set this to (diable)=0?
If the BJT has low Vbe, Ic will continue to flow.
You will break the BJT without realizing it.

[attila]

Hi @Denspa

done: