Denspa

thank you I was completely wrong.

Could you please tell me? Analog Discovery 2 impedance meter measurement. I don't know the code to read the value of Cs below using Script.

I've been using this combination to great advantage. It's portable and great. "digilent.waveforms_3.19.5_armhf.deb" worked. updated. After "digilent.waveforms_3.20.1_armhf.deb" it starts, but ends automatically. Do you know what is the cause?

I also have a Tracer function adapter, but I made my own to measure large currents. The measurements are successful using NoAdater mode. However, I have a slightly complicated problem and would like to ask you a question. The screen shown is an example of measuring Ic/Vbe characteristics. Vrc=5V fixed state. For example, let's say you measured with Single. The initial value of Vrb when measuring for the first time is = 0 (diable). When the measurement is finished, Vrb is the initial value of 500mV. Is there a way to automatically set this to (diable)=0? If the BJT has low Vbe, Ic will continue to flow. You will break the BJT without realizing it.

I was able to display a graph using the plot1 object in my script program. I would like to make the x-axis and y-axis of the graph display logarithmic. Is this possible?

About the character code of the script editor When editing with a script editor in a Windows 10 environment in Japan, the character code seems to be sjis. Is there a way to set it to use with UTF-8 character code?

Thank you for your reply. I didn't notice that there was a hint at the bottom. Knowing this will make things easier from now on. In the document, it is expressed as Wavegen., but the hint is Wavegen1. What does the presence or absence of a subscript number indicate?

The Wavegen feature uses a script to automatically turn on the enable checkbox with .run(). So .stop() does not turn the enable checkbox OFF, but remains ON. Therefore, either [offset] or [inital] voltage will remain output. Is there a way to turn off the enable checkbox used script?