Trigger Condition is not stored correctly in WaveForms

[zelle]

With the following procedure it is not possible to save the desired trigger condition:

• open WaveForms
• activate scope screen
• activate digital scope
• setup trigger condition to `Falling`
• save configuration as xyz.dwf3work
• close WaveForms
• open saved file
• outcome: trigger condition is set to `Rising`

Can anyone help me with this issue?

My assumption is that activation of digital scope screen will always set trigger condition to `Rising`. I wonder if that may influence other settings as well.

[attila]

Hi @zelle

Thank you for the observation.
It will be corrected in the next version on Monday.

[attila]

Hi @zelle

 

[zelle]

Hi attila,

thank you for the fast reply. Ok, it works now after storing and re-opening a file. However, if I change the condition and then turn ON or OFF digital scope, then setting is set back to stored trigger condition. I can't see the sense behind this change.

Best regards
zelle

[attila]

Hi @zelle

The inputs are saved as user selected after leaving the field or on enter. The "Digital" button does not have focus.
If you select a trigger source and press the 'Digital' button the earlier selection does not get saved and last validated selection is loaded. After selecting a source press tab, enter or click in other place.
This behavior will be corrected in the next version.

[attila]

Hi @zelle

 

 

[zelle]

Thank you very much, you are very fast 👍.