Running experiment in analog discovery 2 for the first time with a custom app in python

[Juan05]

I am writing a custom application in Python for an experiment that involves pulses of increasing amplitude. I am using a .py file to control the device and run the experiment. In the attached images, you can see the desired waveform. However, when I first connect the device, the output is incorrect. But, when I run the experiment for the second time, the output is as expected. I am using the Analog Discovery 2 as the device for this experiment. I would greatly appreciate any suggestions or solutions to this issue.

 

 

 

 

 

Edited January 26, 2023 by Juan05

[attila]

Hi @Juan05

After (the first) connection or when changing offset or range use a bit of wait (0.5-2sec) for the offsets to stabilize before starting the acquisition.

[Juan05]

6 minutes ago, attila said:

Hi @Juan05

After (the first) connection or when changing offset or range use a bit of wait (0.5-2sec) for the offsets to stabilize before starting the acquisition.

Thank you, the issue has been resolved!!