I need to calibrate IOTech Tempscan/1000. The manual says to set bit 9 on rear dip switch in order to enable calibration mode, but my unit does not have the 9th bit. I do see a CAL jumper on the motherboard, but I am unclear how to configure it. See attached photo for the jumper. This is URGENT, we are down on mission critical application. Thx.
Question
drcoelho
I need to calibrate IOTech Tempscan/1000. The manual says to set bit 9 on rear dip switch in order to enable calibration mode, but my unit does not have the 9th bit. I do see a CAL jumper on the motherboard, but I am unclear how to configure it. See attached photo for the jumper. This is URGENT, we are down on mission critical application. Thx.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now