Jump to content
  • 0

USB-2416 & AI-EXP32


robertoweninc

Question

We have an installation that was working with a USB-2416 & AI-EXP32. The PC no longer reports them present in Instacal,  tried disconnecting and reconnecting, same result. Checked connection to USB port and power adapter all connected. If we replace the pair with spares will both be associated in Board0 as before, or will we need to add the AI-EXP32 to the USB-2416 in instacal? Also, using with DASYLab. If we get the pair setup in Instacal as above, I assume no changes needed in DASYLab, is that correct? Thanks.

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

  • 0
1 minute ago, robertoweninc said:

If we replace the pair with spares will both be associated in Board0 as before, or will we need to add the AI-EXP32 to the USB-2416 in InstaCal?

if replacing, then new USB-2416 will still be board 0, and the AI-EXP32 will expand the total number of channels shows for the USB-2416.

3 minutes ago, robertoweninc said:

Also, using with DASYLab. If we get the pair setup in InstaCal as above, I assume no changes needed in DASYLab, is that correct?

Assuming you set the the channels EXACTLY the same as they were for the older USB-2416 & AI-EXP32, then yes that is correct.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...