Logic Module Zoom Bug

[RayHaynes]

If it zoom in too far the zoom position changes due to software limit. Settings:

Samples 256M, Rate 100MHz 10% trigger.

Start zooming in somewhere on the right side of the display and when the position rolls over to 1,000,000 the position is lost. The position variable is limited to 1,000,000 but the base keeps going up to 1ns/div. If you are going to keep the Base limit at 1ns/div, 10ns would make more sense with a 100MHz clock limit, but given that, the position variable upper limit needs 2,560,000,000 (I believe).

This makes it impossible to zoom into transactions beyond the 1,000,000 division point. Combine that with the 1000 transaction limit on the protocol module and I'm sadly unable to use this tool.

I'm using the .55 beta on W64

[attila]

Hi @RayHaynes

Uncheck "Position as Division", use position as time.
The "Position as Division" is intended to be used for oscilloscope/timing analysis mode when you change the time base but you want the position to remain fixed on the screen.
I see no point in using this mode for huge captures but the division range will be extended in the next sw version.

Edited October 4, 2022 by attila