Trying to get started with the Zybo-Z7 board and following the "Getting Started with Zynq" tutorial ( here ).
Using Vivado 2018.2 because that's what the latest Pcam tutorial uses (my ultimate application). I can get down to the point where you add the 2 gpio IP blocks. But when "Run Connection Automation" is selected, the popup window does not have an option to select the board interface (switches and LEDs). These are un-commented in the constraint file.
I'm using the latest board files and constraint files. Project Summary shows the correct board part.
I have a feeling I'm missing something simple. I've uninstalled/reinstalled everything. It's a fairly new W10 computer. I've looked at several other getting started type tutorials and no clues there.
I've done embedded systems before so not a complete novice, but i feel like one right now...
Question
Rockytop
Trying to get started with the Zybo-Z7 board and following the "Getting Started with Zynq" tutorial ( here ).
Using Vivado 2018.2 because that's what the latest Pcam tutorial uses (my ultimate application). I can get down to the point where you add the 2 gpio IP blocks. But when "Run Connection Automation" is selected, the popup window does not have an option to select the board interface (switches and LEDs). These are un-commented in the constraint file.
I'm using the latest board files and constraint files. Project Summary shows the correct board part.
I have a feeling I'm missing something simple. I've uninstalled/reinstalled everything. It's a fairly new W10 computer. I've looked at several other getting started type tutorials and no clues there.
I've done embedded systems before so not a complete novice, but i feel like one right now...
Link to comment
Share on other sites
12 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.