Arty7_Lover Posted July 3, 2019 Share Posted July 3, 2019 Hi,everyone I add just zynq IP to block ( Arty z7-20) and lauch sdk with hello world. But I meet error message above. Could you give me a solution ? design_1.zip Link to comment Share on other sites More sharing options...
jpeyron Posted July 3, 2019 Share Posted July 3, 2019 Hi @Arty7_Lover, I have seen this error when the Mode Jumper is set to SD instead of JTAG. I have also seen this error when the ZYNQ processor is not correctly configured. In you other post here it appears you are altering the zynq processor setting. Please attach a screen shot of your vivado block design and your sdk. best regards, Jon Link to comment Share on other sites More sharing options...
Arty7_Lover Posted July 3, 2019 Author Share Posted July 3, 2019 Hi, I attached my 2 files. Link to comment Share on other sites More sharing options...
jpeyron Posted July 3, 2019 Share Posted July 3, 2019 Hi @Arty7_Lover, Here is a completed and verified Hello world project for the Arty-Z7-20 using Vivado 2018.3 and the Digilent board files. Please use the Digilent board files as shown in the attached screen shows. The screen shots show the process taken to complete the project. Here is the data sheet for the IS43 TR16 2 5 6 A - 1 25KB DDR3 part on the Arty-Z7-20. You can see this on page 11 of the schematic here. I believe it is the commercial version. Its my understanding that in our boards files we used the pre-loaded MT41J128M8JP-125 DDR3 controller since it interacts with the on board DDR3 memory correctly and we could configure it to the spec's of the on board DDR. The reference manual shows the DDR3 to be 512 MB(Mega BYTES) which is the same as 4 Gb (Giga bits). best regards, Jon Link to comment Share on other sites More sharing options...
Arty7_Lover Posted July 3, 2019 Author Share Posted July 3, 2019 I have solved my problems due to your help and kind answers. Thanks. Link to comment Share on other sites More sharing options...
jpeyron Posted July 3, 2019 Share Posted July 3, 2019 Hi @Arty7_Lover, Glad to hear that you were able to get your project up and going! best regards, Jon Link to comment Share on other sites More sharing options...
Question
Arty7_Lover
Hi,everyone
I add just zynq IP to block ( Arty z7-20) and lauch sdk with hello world.
But I meet error message above.
Could you give me a solution ?
design_1.zip
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.