I've recently bought a Zybo z7010 board and had a go at running the example given here: https://reference.digilentinc.com/learn/programmable-logic/tutorials/zybo-getting-started-with-zynq/start#tutorial
The bitstream was generated successfully as expected but when I load the application on to the Zynq PS, I observe that:
None of the LEDs are lit when the corresponding buttons are flicked.
No message is displayed on the UART console when any of the switches are pressed.
Can anyone provide some hints on how would I go about debugging the issue?
Some info w.r.t my build environment:
Bitstream generated using Vivado 2016.4 (Windows 10)
Power source: wall (JP7 set to Wall)
JP5 set to JTAG.
Cable: simple USB cable which came with my smartphone. (When JP5 is set to QSPI, I can see u-boot booting a preloaded busybox image so the cable seems to be working fine.)
Question
ahmrah01
Hi,
I've recently bought a Zybo z7010 board and had a go at running the example given here: https://reference.digilentinc.com/learn/programmable-logic/tutorials/zybo-getting-started-with-zynq/start#tutorial
The bitstream was generated successfully as expected but when I load the application on to the Zynq PS, I observe that:
Can anyone provide some hints on how would I go about debugging the issue?
Some info w.r.t my build environment:
Please advise.
Regards,
ahmrah01
Link to comment
Share on other sites
11 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.