The Hardware Manager detected the PS and PL once but then the OS crashed and I had to reboot. After that, I get this error message trying to connect to the device:
ERROR: [Labtoolstcl 44-26] No hardware targets exist on the server [localhost] Check to make sure the cable targets connected to this machine are properly connected and powered up, then use the disconnect_hw_server and connect_hw_server commands to re-register the hardware targets.
I ran the hw_server manually as administrator, ran Vivado 2015.3 IDE as administrator and went to the Hardware manager. In TCL window, I type:
connect_hw_server -url Gazi-Laptop:3121 and hit enter and I get the same message. I have tried two different USB cables (one from Digilent) and Different USB ports. I have even uninstalled and reinstalled Vivado 2015.3 Design Edition along with Cable Drivers. I have tried manually reinstalling the cable drivers as mentioned on Xilinx. However, I cannot communicate with the device except for that one time after which my system crashed. JP5 is set to JTAG.
Question
Gazi
Hello there,
Board: ZYBO
IDE: Vivado 2015.3 Design Edition
OS: Windows 10 X64
Host ID: Gazi-Laptop
The Hardware Manager detected the PS and PL once but then the OS crashed and I had to reboot. After that, I get this error message trying to connect to the device:
ERROR: [Labtoolstcl 44-26] No hardware targets exist on the server [localhost]
Check to make sure the cable targets connected to this machine are properly connected
and powered up, then use the disconnect_hw_server and connect_hw_server commands
to re-register the hardware targets.
I ran the hw_server manually as administrator, ran Vivado 2015.3 IDE as administrator and went to the Hardware manager. In TCL window, I type:
connect_hw_server -url Gazi-Laptop:3121 and hit enter and I get the same message. I have tried two different USB cables (one from Digilent) and Different USB ports. I have even uninstalled and reinstalled Vivado 2015.3 Design Edition along with Cable Drivers. I have tried manually reinstalling the cable drivers as mentioned on Xilinx. However, I cannot communicate with the device except for that one time after which my system crashed. JP5 is set to JTAG.
Any help is appreciated.
Link to comment
Share on other sites
12 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.