jfdo

Thank you for the replies to both Attila and Fausto. That's helpful! Best Fernando

Hi all, I would like to know whether there examples or tutorials to control analog discovery and other peripherals through Labview? Thank you. Fdo

Hi @ Attila, Thank you. So, the audio output is a voltage amplifier? Would it amplify the current too? or only the voltage?

Hi @ Attila, Does 33R PTC mean 33 Ohms Positive Temperature Coefficient?

Thank you.

Hi team, In the impedance measurement setup, I wonder whether the Scope 1 and Scope 2 negative terminals should be grounded ? Thank you. ,

Hi Attila, Thank you for the Answer. I can see can set the WaveGen Amplification to 0.01 to 100. Is this the voltage amplification? or both current and voltage? What does 33R PTC mean? Thanks

Hi, I got this amplifier circuit from the project "Building a DIY Speaker". what would be the gain of this amplifier? Can that be used as a Voltage and Current amplifiers or just one? I am looking for an current amplifier to amplifier 10mA to about 200mA? Can anyone recommend a circuit?

Hi, May I know what is the maximum output current and voltage of the Audio output of the Analog Discovery? And maximum Output power? If I set the WaveGen to 3V output, what would be the out of the Audio output? Thank you.

Thank you very much for the answer and screen shots!

Is the RMS value calculation available? If I zoom it, and position the cursers, still it would not perform the average or the RMS value?

Thank you Attila! Could you please send me an example to use the Script tool? Thank you. Best Regards

Hi Fausto, Thank you for the reply. I have the Analog Discovery (Black colour) one. The first of Analog Discovery models. MAX 6675 uses SPI communication. The pins are; GND = Connect to system ground. This ground needs to be in common with the MCU. VCC = Connect to 3.0 – 5.5V. Typically connected to MCU operating power. SCK = Serial Clock Input. Connect to any digital pin on MCU. CS = Chip Select. Connect to any digital pin on MCU. SO = Serial Data Output. Connect to any digital pin on MCU. I can do this with a MCU. But interested to use the Analog Discovery as the MCU. Needs to create an instance (object) of MAX6675 to read the temperature values. As such we don't need ADC to temperature conversion metric. Appreciate any input on this. Thank you. Best Wishes. Fernando

Hi all, I would like to know whether MAX6675 K-type Thermocouple Temperature Sensor can be directly connected to the Analog discovery? Has anyone tried it? Link: https://www.auscomtech.com.au/product/max6675-k-type-thermocouple-temperature-sensor-0-600-degrees-module-arduino/ Thank you. Best Wishes Fernando

Hi all, I obtained the attached waveform. I wish to calculate the average value between the vertical and horizontal cursers. I appreciate if anyone could let me know whether there is an built in function in the "waveform" software to do this, and if so please direct me to the right menu. Thank you. Best Regards Fernando