-
Posts
5,826 -
Joined
-
Last visited
jpeyron's Achievements
Single Status Update
-
sir, i am using zedboard to interface pmod wifi but while creating block diagram ssdram and pmod pheripheral blocks are not present.Are there any extra modules we have to install for pmodes.
-
Hi @harika,
We ask that you post questions on the forum so others that might have similar questions can benefit from the thread. Here is the zedboard resource center. Make sure that you have installed the digilent board files and the you select the digilent board file when creating a zedboard project. Here is a tutorial on using IP Cores.
thank you,
Jon
-
Thank u for the reply, But actually in zedboard DD3SDRAM Peripheral is PS part one, so for zedboard if we go for MIG port the output is as shown in picture1. So, for this i refered to ug586_7series_MIS.pdf-xilinx UG586 7 series fpga memory interface solutions v1.9 and v1.9a userguide.
I found that in MIG block with DD3SDRAM output it will be like in picture2. But in your videos there is extra clk that is in block of MIG with output DD3SDRAM shown in picture3, how can we insert that.
- Show next comments 3 more
-