tdavis

Hi: I do own the item in the first link listed above - curve tracing PCB - and have used it. https://digilent.com/shop/transistor-tester-for-analog-discovery-enables-characteristic-curve-tracing-for-diodes-and-transistors/ There are some comments I have with it, but I need to use it again to remember them. Probably another question for the group of experts. The bench instrument we typically use is a Keithley 2400.

I am stepping into the middle of a conversation. thanks for asking the question Josh. Our group would use this feature too. Is there a price point on the adapter yet, or is that still to be determined? Tim

Hi Attila. I focused to the attached timing diagram trying to include the following 2 comments. I believe I corrected what was necessary to follow these comments. In the earlier setup the AWG is triggered by the PG start and not by the DIO line. (timing diagram was on your last setup) The AWG output is configured to be in idle/initially high and not low. (both timing patterns for W1 match now) Are there more corrections needed? This timing diagram is getting used for more people I work with. Thanks, Tim ad2_pg_arb_timing_diagram_rev2_attila.pdf

The attached report document shows a timing diagram in Figure 1 which is what was interpreted from previous post. Please advise if the diagram is incorrect and what needs to be updated. I changed the arb period from 6us to 4us and extended the wait by another +1us, and the PG and ARB edges once again aligned. In principle, the diagram was checked. Please advise. ad2_pg_arb_timing_diagram_attila.pdf

I setup my AD2 per the way the AD3 graphic was shown. The results do match - and I have attached another working report. I note the trigger change and rising edge defined in W1. However, the timing diagram including the trigger, the graphical arb output signal (W1) and the specified wait of 11.8us is not clear to me. I can't draw it - meaning I don't know. What keys did you know that you so quickly could set those times? I will be asked to do the same as the output PW (low portion) of the arb signal will be changed as an independent variable. Thanks for doing the example using the 35us of the total PG pattern period, which is where the patter repeat should start. Please advise. ad2_questions_graphics_attila.pdf

Hi Attila. Good to work with you again. Last time was around August 2019 and that post/work has been archived regarding SAs and RMS. Are you able to attach a .dwf3work file? If not I will go through the screenshot by section. I like that you also included the AD2's scope in the result where I had used an R&S RTH1004 in the documentation.

ad2_questions_with_graphics_trigger.pdf GOAL: Reduce time delay using trigger from PG to ARB/Wavegen1 Pattern Generator is master instrument - delivering trigger1. Arb or Waveform1 is slave instrument and is triggered by the RST signal (DIO1) of the PG wired to trigger1. Want to learn to better specify the 3us pulse with no delay drawn in the arb graphical setup tool. The high and low voltage amplitude of the arb output are critical in the design. Ideally no time delay is wanted from trailing edge of PG signal (trigger) to trailing edge of W1 (arb) signal. PDF attached with 2 scope photos and patterns1 and wavegen1 setup windows. If there are good examples to refer to, please let me know.