oldViking

Hi, While creating a MicroBlaze block, it became necessary to supply the reset signal from the Arty S7 to the resetn pin of the Clocking Wizard. I believe this was accomplished successfully. However, how do I know that the port signal name "reset" is actually connected to the Arty S7 schematic net "CK_RST" ? Thanks oldViking

Hi, I am trying to operate the XADC on my Arty S7. I think I have the wizard set up to operate in a continuous mode. When the wizard is open, it shows a pinout of the module. Two of the inputs are the dclk_in, and the reset_in. Is it my responsibility to add VHDL code that will connect these pins to the correct signal ? If so do you have some sample VHDL code that will provide some guidance ? I have no idea where to get a reset signal from. As a first step, before looking at conversion data, I would be satisfied to see the output signal eoc_out changing states in a predictable manner (on my scope). Thank you oldViking

Hi, I went into the device manager, USB controllers on my win11 machine. After having plugged the Arty S7 into my USB port, there does not appear to be any presence of a Digilent device. I have tried this on two different USB ports, using two different USB cables. Thank you oldViking

Last week I connected my Arty S7 development board to the USB port on my laptop. It appears to be completely dead because none of the normal LED activity appeared. I have tried 2 other USB ports on the laptop with the same result. Where should I go from here ? Thanks oldViking