Jump to content
  • 0



On page-2 of the users manual for the HS3 it shows the pin outs for the HS3 and the target device. If the views shown are the bottom and when mating, the signals will be reversed. What pin outs do I use for my target PCB? Also is there a recommended 14-pin 2.0mm shrouded connector (mfg and part number)?
Mike Handy

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

I copy here the anwer you got on Digilent support:

For your PCB you should use the pinout shown on the right side image on the page you mentioned.

Here is the connector we use:

I hope this answers your question. Please write me if you need more information.




Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...