I just received my Zybo Z7-10 board a few days ago, and have been working on it. I think the USB type A (the USB OTG) is not working. Because I have plugged a simple flash memory with a LED on its back and when I plug it, its LED doesn't turn on. I have another FPGA board "Basys3", and if I plug my flash memory, the back LED on flash memory turns on. I have implemented a Petalinux on the board and it cannot also recognize that USB when I plug it. I have also tested the USB A voltage pins,the voltage between the far right and left pins, and the voltage difference is zero which has to be around 5 volt.
Since the warranty time is 30 days, I was wondering if one of the technicians could help me whats going on and if the board is defective.
Question
ashkan
Hello
I just received my Zybo Z7-10 board a few days ago, and have been working on it. I think the USB type A (the USB OTG) is not working. Because I have plugged a simple flash memory with a LED on its back and when I plug it, its LED doesn't turn on. I have another FPGA board "Basys3", and if I plug my flash memory, the back LED on flash memory turns on. I have implemented a Petalinux on the board and it cannot also recognize that USB when I plug it. I have also tested the USB A voltage pins,the voltage between the far right and left pins, and the voltage difference is zero which has to be around 5 volt.
Since the warranty time is 30 days, I was wondering if one of the technicians could help me whats going on and if the board is defective.
Thank you
Link to comment
Share on other sites
13 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.