• 0

Ethernet shield


Monics

Question

I am looking at using the Digilent modules together with Labview LINX (Makerhub), and I need a setup with ethernet connection to Labview/LINX.


Digilent have retired the 410-211, Network Shield... but will I be able to use the Pmod NIC100 (together with max32 or uC32) and get support for ethernet interface through LINX....?

Br,
Martin Christiansen.

Link to comment
Share on other sites

7 answers to this question

Recommended Posts

Hi Austin...

OK, I will desribe what I intend to do.

I want a board which support ethernet access, fx like the digilent max32 board including the network shield. But, the network board is retired.... so what can I use instead?

Fx. Could I use the NIC100 with a digilent board to communicate with LINX over Ethernet?

Any experience would be nice to hear about.

br,

Martin C.

 

Link to comment
Share on other sites

AustinStanton

I find the speed of the serial interface to slow, 9600 baud.

The Ethernet should support much higher speed and respons.

Is there any other Ethernet boards for Arduino like boards, than the Digilent?

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.