Bill of material for Xilinx CoolRunner-II CPLD Starter Board

[nirav]

Hi,

I have a CoolRunner-II CPLD Starter Board Rev F. I am looking for bill of material to look up various parts used on that starter board. Please guide me where to find that BOM.

Thank you,

Nirav

 

[D@n]

@nirav,

I haven't seen Digilent publish any BOM's, but you should be able to find most of what you need on the schematic, here.

Dan

[nirav]

Hi Dan,

I was particularly looking for part number for transistor IC Q1, Q2.

Nirav

[jpeyron]

Hi @nirav,

Both Q1 and Q1 are MMBT3906DW1t1 On-Semiconductor Dual General purpose transistors.

cheers,

Jon

[BYTEMAN]

Hi,

I've a CoolRunner-II Rev2.0 board, I know is rather old but I kindly request the code for the mating male connector for PMOD J1, J2, j3, J4 and for the 40-pin J5 connector because I'm to develop an application and connect it through these connectors and in order to avoid any damage to the connector board I request the exact male mating connectors code that I've to to use or alternatively a datasheet to find some equivalent ones,

Thanks for your time!

Best regards

Grinch

[jpeyron]

Hi @BYTEMAN,

J1 - J4 follows the pmod standard. Look at section 4. J5 is a unloaded 2x20 that shares the 100 mil pitch of the Pmod ports.

thank you,

Jon

[BYTEMAN]

11 hours ago, jpeyron said:

Hi @BYTEMAN,

J1 - J4 follows the pmod standard. Look at section 4. J5 is a unloaded 2x20 that shares the 100 mil pitch of the Pmod ports.

thank you,

Jon

Thank you!