HansV Posted June 20, 2017 Share Posted June 20, 2017 Hi, In the attached picture i try to trigger in 2 way's 1. Protocol on value: h48[H] 2. Direct on the Falling edge Both ways don't work the system randomly triggers on what? Thanks in advance, Hans. Link to comment Share on other sites More sharing options...
attila Posted June 21, 2017 Share Posted June 21, 2017 Hi @HansV The trigger on Protocol value should work. First please make sure the UART rate is properly configured, then set the value to trigger on. Link to comment Share on other sites More sharing options...
HansV Posted June 21, 2017 Author Share Posted June 21, 2017 Hi Atilla, Thanks for the quick response...top! I see now that it only works with Trigger: in the "Normal" position, not in the "Auto" position. Normaly i expect that "Auto" is always good. Hans Link to comment Share on other sites More sharing options...
Question
HansV
Hi,
In the attached picture i try to trigger in 2 way's
1. Protocol on value: h48[H]
2. Direct on the Falling edge
Both ways don't work the system randomly triggers on what?
Thanks in advance,
Hans.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.