I am using the Waveforms APIs to process the raw waveform data from the oscilloscope of AD2 to a C++ code. My other requirement is to use the logic analyzer simultaneously to get the data bit stream of data as well.
1. I was able to do this on the Waveforms 2015 GUI but is it possible using the APIs?
2. There are analyzers (SPI, I2C, Serial, CAN etc.) present in the Waveforms GUI, but is there a preset to do the same in the API? (not just being able to read 0/1 but analyse the SPI/CAN bus)
Question
shabbirahmed
Hi,
I am using the Waveforms APIs to process the raw waveform data from the oscilloscope of AD2 to a C++ code. My other requirement is to use the logic analyzer simultaneously to get the data bit stream of data as well.
1. I was able to do this on the Waveforms 2015 GUI but is it possible using the APIs?
2. There are analyzers (SPI, I2C, Serial, CAN etc.) present in the Waveforms GUI, but is there a preset to do the same in the API? (not just being able to read 0/1 but analyse the SPI/CAN bus)
Thanks,
Shabbir
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.