I'm using the Pitsco TETRIX PRIME for NI myRIO and the sensor board that comes with it is from Digilent, but is different than the motor adapter. The kit comes with two DC motors and each has an encoder attached. I can only read from the encoder plugged into "motor1" port. Is it possible to read the other motor's encoder? I read this forum, but I think it's a little different:
Question
rdoswald
Hello,
I'm using the Pitsco TETRIX PRIME for NI myRIO and the sensor board that comes with it is from Digilent, but is different than the motor adapter. The kit comes with two DC motors and each has an encoder attached. I can only read from the encoder plugged into "motor1" port. Is it possible to read the other motor's encoder? I read this forum, but I think it's a little different:
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.