Jump to content
  • 0

Booting a PetaLinux Image on Genesys2 FPGA board with SD Card

Sunil kumar



I am trying to boot a petalinux image on Genesys2 FPGA board with SD card. I tried the steps mentioned in AMD doc UG1144, but don't see any boot messages in the serial console. Are there any steps specific to Genesys2 board that I need to follow? Pl. suggest.



Link to comment
Share on other sites

1 answer to this question

Recommended Posts

  • 0

Are you using microblaze or zynq petalinux template?

You did not provide enough information to properly specify the issue you are having.
If you are using microblaze first thing to look for should be the fsbl messages (by enabling debug).

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...