I'm trying to get a basic led glowing project up using a bare metal application. After I downloading the bit stream and the .elf file, I'm not seeing any change on the board. Even the uart terminal is blank, even though connection is there. The board jumpers are set to jtag mode! I'm sure there is a pretty simple reason as to what I'm not doing right! But I'm not able to put my finger on it! Can someone please explain! I have attached snapshot of my Vivado block design and the c code. after dumping the .elf file on the board
Question
Axe
Hi,
I'm trying to get a basic led glowing project up using a bare metal application. After I downloading the bit stream and the .elf file, I'm not seeing any change on the board. Even the uart terminal is blank, even though connection is there. The board jumpers are set to jtag mode! I'm sure there is a pretty simple reason as to what I'm not doing right! But I'm not able to put my finger on it! Can someone please explain! I have attached snapshot of my Vivado block design and the c code. after dumping the .elf file on the board
Link to comment
Share on other sites
10 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.