Patterns and I2C Instrument not working together

[Rohan16]

I am trying to run patterns and I2C instruments at the same time. configured the DIO 39 pin  such that it generate high signal for 1 second and low signal  for 10 seconds. 

Both I2C's and Pattern's code works fine when run independatly but does not work when clubbed together as below .

Are there some settings to do when two instruments are clubbed together ?

what could be the solution so that patterns and I2C instruments  run independently at the same time ?

 

 

Thanks in advance

Edited March 28 by Rohan16
removing image

[attila]

Hi @Rohan16

You can use StaticIO to drive the DIO 0/1. If not Z this has higher priority over the DIO than Patterns and Protocol.

[attila]

Hi @Rohan16

Only one interface can run at a time that requires the same device resource.

[Rohan16]

@attila Thanks for your reply .so the conclusion is I2C and pattern generator  cant run at the same time ?  is there a  way to just make pin DIO39 high for 1 second apart from using Pattern tool which would not interfere with the operation of I2C ?

Edited March 27 by Rohan16

[Rohan16]

@attila This is very much helpful . Thanks

.