Paul Chang Posted February 7 Share Posted February 7 (edited) Dear Sir, Our zedboard's power led was not turned on after plugged the power line. It does not work if we try to program by Jtag or boot from sd card eithter. May you advise any further step to fix it? Best Regards, Paul Edited February 15 by Paul Chang Link to comment Share on other sites More sharing options...
0 Paul Chang Posted February 21 Author Share Posted February 21 Dear sir, Any suggestions for this situation? best regards paul Link to comment Share on other sites More sharing options...
0 Ionut Posted March 7 Share Posted March 7 Hello, After plugging the power supply to the board, do you mean that LD13 (POWER) LED did not turn on? What power supply did you use: the 12V supply that came in the box with the board, or another supply? Could you try to turn the board on and off several times from the SW8 power switch, and check if the problem goes away? Also, when did you buy the respective board? Best Regards, Ioan. Link to comment Share on other sites More sharing options...
0 Paul Chang Posted March 8 Author Share Posted March 8 (edited) Hi @Ionut, 1. LD13 LED did not turnn on. 2 The 12V supply that came in the box with the board. 3.Turn the board on and off several times and it still can not power on. Best Regards, Paul Edited March 8 by Paul Chang Link to comment Share on other sites More sharing options...
0 Ionut Posted March 8 Share Posted March 8 Hello, Since LD13 LED is off, it likely means the power supply on the ZedBoard has an issue. Did the board always behave like this, or it worked fine at the beginning and then at some point it started to behave like this? Also, do you remember when you bought this board? Best Regards, Ioan. Link to comment Share on other sites More sharing options...
0 Paul Chang Posted March 11 Author Share Posted March 11 (edited) Hi @Ionut It worked fine at the beginning and then at some point it started to behave like this. We bought this board in 2023/11. Best Regards, Paul Edited March 11 by Paul Chang Link to comment Share on other sites More sharing options...
Question
Paul Chang
Dear Sir,
Our zedboard's power led was not turned on after plugged the power line. It does not work if we try to program by Jtag or boot from sd card eithter. May you advise any further step to fix it?
Best Regards,
Paul
Edited by Paul ChangLink to comment
Share on other sites
5 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now