shashi Posted September 18, 2016 Share Posted September 18, 2016 Hi all.., As shown in the attached image, the ethernet option for hardware cosimulation is not enabled while I am trying to run one DSP application on Zed Board. Does this require some settings change or is Hardware cosimulation through point to point ethernet not available for Zed board? Thanks in advance. Link to comment Share on other sites More sharing options...
jpeyron Posted September 19, 2016 Share Posted September 19, 2016 Hi shashi, Unfortunately Sysgen questions are outside of the scope of this forum, though you may get a response from the community. However, I would suggest searching the Xilinx and or mathworks forums first, then posting your question there. thank you, Link to comment Share on other sites More sharing options...
shashi Posted September 20, 2016 Author Share Posted September 20, 2016 Thanx for the reply Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.