Programming the Zedboard using Quad SPI not working

[s.gafoor]

Hi

I am using zedboard xc7z020 and vivado version 2016.2. I am familiarising the zedboard as part of my project. Succesfully run the tutorial on getting started with zynq (https://digilent.com/reference/learn/programmable-logic/tutorials/zedboard-getting-started-with-zynq/start). Continuing to this I have done Programming the Zedboard using Quad SPI. (https://digilent.com/reference/learn/programmable-logic/tutorials/zedboard-programming-guide/start?_ga=2.147944692.2119754312.1704773319-271982374.1696499519).

All steps are done according to the tutorial and programmed the flash with BOOT.bin shows 'Flash Operation Successful'. But the board is not working & done led did not light up.

Same BOOT.bin file copied to sd card and loaded to the board also not working.

Please suggest a solution to this problem.

Regards

s.gafoor