s.gafoor

Hi I am using zedboard xc7z020 and vivado version 2016.2. I am familiarising the zedboard as part of my project. Succesfully run the tutorial on getting started with zynq (https://digilent.com/reference/learn/programmable-logic/tutorials/zedboard-getting-started-with-zynq/start). Continuing to this I have done Programming the Zedboard using Quad SPI. (https://digilent.com/reference/learn/programmable-logic/tutorials/zedboard-programming-guide/start?_ga=2.147944692.2119754312.1704773319-271982374.1696499519). All steps are done according to the tutorial and programmed the flash with BOOT.bin shows 'Flash Operation Successful'. But the board is not working & done led did not light up. Same BOOT.bin file copied to sd card and loaded to the board also not working. Please suggest a solution to this problem. Regards s.gafoor

Hi @JColvin Zedboard boot up and basic setup are done successfully. But the "Enable port persist" option in the port advanced settings(reference from the 'zedboard getting started guide' ) is absent on my system. I selected 'Use FIFO buffers'. I am using windows 11 pro. Is there arise any issue regarding this? My PC shows below attached window. I am planning to do JTAG programming.

Hi @JColvin Copied the sd_image folder contents(5 files) from Out-Of-Box Demo and done the basic setup. What are the extra files to load in the SD card? Please provide the details.

Hi @JColvin Copied the sd_image folder contents(5 files) from Out-Of-Box Demo and done the basic setup. What are the extra files to load in the SD card? Please provide the details. Thank you, S.gafoor

@JColvin Thank you

hi, I have lost 4GB SD card of zedboard (ZYNQ XC7Z020-CLG484), which is already provided with the kit. So I can't able to do the hardware set up on the board. Is the preloaded software in the SD card is downloadable? Please let me know a solution.