I am having the same issue seen in the following form post:
I noticed as soon as I send the UART command the protocol function stops running no matter what I do. I have even tried to have it run again right after I send the command. I know that I am sending it since when I scope the lines I can see what I am sending and the response.
Question
ctighe
Hello,
I am having the same issue seen in the following form post:
I noticed as soon as I send the UART command the protocol function stops running no matter what I do. I have even tried to have it run again right after I send the command. I know that I am sending it since when I scope the lines I can see what I am sending and the response.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now