When using the UART protocol decoder of the logic analyzer tool, the decoded waveform is correct, but the h00 byte is detected as a "Break" trigger condition.
Configuration:
DIO0 UART TX, auto standard rate (19.2110656 kbps).
Trigger source: DIO0 Protocol/Break
(The measured length of the low signal level is 469.3 us.)
The same thing happens when DIO0 UART TX is configured to Manual rate, 19.2 kbps.
Question
TOIVI
Hi @attila
When using the UART protocol decoder of the logic analyzer tool, the decoded waveform is correct, but the h00 byte is detected as a "Break" trigger condition.
Configuration:
DIO0 UART TX, auto standard rate (19.2110656 kbps).
Trigger source: DIO0 Protocol/Break
(The measured length of the low signal level is 469.3 us.)
The same thing happens when DIO0 UART TX is configured to Manual rate, 19.2 kbps.
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now