omikron Posted September 1, 2016 Share Posted September 1, 2016 Hello It seems that Zybo Board files at Git are faulty. It gives some error messages, when connecting Leds to GPIO by assistant. See the picture. XDC master file has miss typo at one of VGA_R bits also. Link to comment Share on other sites More sharing options...
Bianca Posted September 1, 2016 Share Posted September 1, 2016 Hello, The board files and the XDC from the reference page here are not faulty. The thing that draws my attention on this screenshot is that you don't have a Zynq IP in your design. The the absence of that IP you don't have what leds to connect to the AXI GPIO. Please follow this tutorial on Getting Started with Zynq and tell me if you have further problems with the board files, XDC file or the board itself. Best regards, Bianca Link to comment Share on other sites More sharing options...
omikron Posted September 1, 2016 Author Share Posted September 1, 2016 Same result. I put Zynq IP first, clicked to the automation things. Then, I right clicked 4btns at the Board tab, OK, it made GPIO and connected buttons. Finally I right clicked 4leds in the board tab and it made the error. Vivado is 2016.1 Link to comment Share on other sites More sharing options...
Bianca Posted September 1, 2016 Share Posted September 1, 2016 Ok, I will install Vivado 2016.1 and give it a try. Not long ago I tested this design with Vivado 2015.4 and I had no troubles. Bianca Link to comment Share on other sites More sharing options...
jpeyron Posted September 1, 2016 Share Posted September 1, 2016 Hello, I tested this design in vivado 2016.1 with not issue as shown below. Could you please take a screen shot of the error you found in the vga_r along with the errors you have with the design. The errors I am able to make out from you initial post seem to be related to trying to have led_4bits on both GPIO and GPIO2. thank you, Jon Link to comment Share on other sites More sharing options...
Question
omikron
Hello
It seems that Zybo Board files at Git are faulty.
It gives some error messages, when connecting Leds to GPIO by assistant. See the picture.
XDC master file has miss typo at one of VGA_R bits also.
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.