DAQami and the USB-230 Series

[dlib]

I was curious if it was possible to use this software to have the Analog Outputs generate waveforms simultaneously??  Is a Ramp or Sawtooth waveform supported?  If the sawtooth is supported can it be below 1Hz?

Thanks for any information

[JRys]

DAQami typically uses a scanning function for analog output, which clocks the outputs simultaneously. However, when the update rate is low ( < 100 Hz),  it switches to single-point updates, which are not simultaneous. 

[dlib]

Is a Ramp supported?? 

If the step sizes are small enough then the updates could be made fast and thus the ramp rate could be adjusted while the outputs were synchronized.

Thanks!

[JRys]

DAQami supports Sine, Square, Triangle, or Sawtooth waveforms.

 

 

[dlib]

Is TracerDAQPro still supported?  Would that work for a ramp??

[JRys]

We still answer questions about TracerDAQ Pro, and it does have a ramp function output, which is like a sawtooth waveform in DAQami.