s.gafoor Posted October 11, 2023 Share Posted October 11, 2023 (edited) hi, I have lost 4GB SD card of zedboard (ZYNQ XC7Z020-CLG484), which is already provided with the kit. So I can't able to do the hardware set up on the board. Is the preloaded software in the SD card is downloadable? Please let me know a solution. Edited October 11, 2023 by s.gafoor Link to comment Share on other sites More sharing options...
0 JColvin Posted October 11, 2023 Share Posted October 11, 2023 Hi @s.gafoor, This would have been the Out-Of-Box Demo which is available in the Additional Resources section of the Zedboard Resource Center: https://digilent.com/reference/programmable-logic/zedboard/start#additional_resources. Let me know if you have any questions. Thanks, JColvin Link to comment Share on other sites More sharing options...
0 s.gafoor Posted October 12, 2023 Author Share Posted October 12, 2023 @JColvin Thank you Link to comment Share on other sites More sharing options...
0 s.gafoor Posted October 18, 2023 Author Share Posted October 18, 2023 (edited) Hi @JColvin Copied the sd_image folder contents(5 files) from Out-Of-Box Demo and done the basic setup. What are the extra files to load in the SD card? Please provide the details. Thank you, S.gafoor Edited October 18, 2023 by s.gafoor Link to comment Share on other sites More sharing options...
0 s.gafoor Posted October 18, 2023 Author Share Posted October 18, 2023 Hi @JColvin Copied the sd_image folder contents(5 files) from Out-Of-Box Demo and done the basic setup. What are the extra files to load in the SD card? Please provide the details. Link to comment Share on other sites More sharing options...
0 JColvin Posted October 19, 2023 Share Posted October 19, 2023 Hi @s.gafoor, I'm not certain what other SD card files you might be referring to. Did the Zedboard not boot up as per the instructions in the readme file that was included in the sd_image folder? Thanks, JColvin Link to comment Share on other sites More sharing options...
0 s.gafoor Posted October 27, 2023 Author Share Posted October 27, 2023 Hi @JColvin Zedboard boot up and basic setup are done successfully. But the "Enable port persist" option in the port advanced settings(reference from the 'zedboard getting started guide' ) is absent on my system. I selected 'Use FIFO buffers'. I am using windows 11 pro. Is there arise any issue regarding this? My PC shows below attached window. I am planning to do JTAG programming. Link to comment Share on other sites More sharing options...
Question
s.gafoor
hi,
I have lost 4GB SD card of zedboard (ZYNQ XC7Z020-CLG484), which is already provided with the kit. So I can't able to do the hardware set up on the board. Is the preloaded software in the SD card is downloadable? Please let me know a solution.
Edited by s.gafoorLink to comment
Share on other sites
6 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now