JuanP Posted August 23, 2023 Share Posted August 23, 2023 Does it accept 4-20mA signals? Does it take +/- 10V signals? Would it be possible to connect your system to Matlab and get the data out here? If so, how? Link to comment Share on other sites More sharing options...
0 DAQman Posted August 23, 2023 Share Posted August 23, 2023 The USB-2416 analog input does not measure current. However, if you employ a 250-ohm shunt resistor, it can measure the voltage drop. In this case, 4mA will be 1 volt and 20mA will be 5 volts. For this case, you could use the 5-volt range. If you instead used a 500 ohm shunt resistor, use the 10-volt range. Here's a (very) short article about 4-20mA. There is no MatLab. The following is a list of what they do support: https://www.mathworks.com/hardware-support/measurement-computing.html Link to comment Share on other sites More sharing options...
Question
JuanP
Does it accept 4-20mA signals?
Does it take +/- 10V signals?
Would it be possible to connect your system to Matlab and get the data out here? If so, how?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now