UART Send hex values?

[outback]

I can't find the way to input hex values. Most of the sensors which communicate via UART already have examples of communication protocol with hex examples. I see only "text" and "number" as an input where event the 10-15 years old serial communication software does this if needed. Like CuteCom etc.

Is there a way? Other than writing a script?

[attila]

Hi @outback

You can enter 'escape' codes or select Number mode for TX and RX.

[outback]

On 7/26/2023 at 5:56 AM, attila said:

Hi @outback

You can enter 'escape' codes or select Number mode for TX and RX.

But i want to send hex format. Receiving exists but sending is only number or text....

[attila]

Hi @outback

Then use the 'h' prefix just like it is in the receive.

[outback]

On 8/2/2023 at 11:25 AM, attila said:

Hi @outback

Then use the 'h' prefix just like it is in the receive.

Thank you so much