In the custom board that I am having , the SOC is ZYNQ 7010.
There are two 16bit ADCs (4 channels in total) connected to FPGA using SPI interface.
These ADCs will be used to capture the voltage transients and the computed values will be stored in eMMC(NAND flash).
I have two mains doubts:-
a) How to create .XSA in vivado that incorporates two ADCs and eMMC interfaced with FPGA ?
Pls share any reference project where this/or similar implementation has been done.
b) How to test ADC interface in kernel? and/or application?
I will have to write a test application. Basically I need to read the values output by the ADC and this should match with the expected value (in ideal scenario).
I am sharing the schematic part of one of the ADCs here:-
Question
Sameeksh Shetty
Hi,
In the custom board that I am having , the SOC is ZYNQ 7010.
There are two 16bit ADCs (4 channels in total) connected to FPGA using SPI interface.
These ADCs will be used to capture the voltage transients and the computed values will be stored in eMMC(NAND flash).
I have two mains doubts:-
a) How to create .XSA in vivado that incorporates two ADCs and eMMC interfaced with FPGA ?
Pls share any reference project where this/or similar implementation has been done.
b) How to test ADC interface in kernel? and/or application?
I will have to write a test application. Basically I need to read the values output by the ADC and this should match with the expected value (in ideal scenario).
I am sharing the schematic part of one of the ADCs here:-
Thank you.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now