Jump to content
  • 0

Load Cell Logging Capability - MCC USB-1608GX


MBinger

Question

3 answers to this question

Recommended Posts

  • 0

Hello,

If you have a typical load cell, the output is too small for the USB-1608GX to measure accurately. The average load cell reading is less than 20 mV. It would be best to have a signal conditioner to amplify the signal. However, it must have a wide bandwidth if the signal is present for only 10uS. The USB-1616HS is a better choice for a device because it has a 100 mV range and is faster than the USB-1608GX. It can run a single channel at 1M S/s, which would net you ten samples for the 10uS contact closure.

Best regards,
John

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...